PIC24FJ256GB106-I/PT

133,795 

Features:CPU
Up to 16 MIPS performance
16 x 16 Hardware Multiply, Single Cycle Execution
12-bit x 16-bit Hardware Divider
C Compiler Optimized Instruction Set
nanoWatt Power Managed Modes
Run, Idle and Sleep modes
Multiple, Switchable Clock Modes for Optimum Performance and Power Management
Run mode: 1 mA/MIPS, 2.0V Typical
Sleep mode Current Down to 100 nA Typical
Standby Current with 32 kHz Oscillator:2.5 uA,2.0V typical
Flash Program Memory
Self-Reprogrammable under Software Control
10,000 erase/write cycles
20 year data retention
EEprom emulation capable
System
Internal oscillator support – 31 kHz to 8 MHz, up to 32 MHz with 4X PLL
On-chip LDO Voltage Regulator
JTAG Boundary Scan and Flash Memory Program Support
Fail-Safe Clock Monitor – allows safe shutdown if clock fails
Watchdog Timer with separate RC oscillator
Analog Features
10-bit ADC, 16 channels, 500k samples per second
Three Analog comparators
Universal Serial Bus Features
USB v2.0 On-the-Go compliant
Dual role capable, can act as either Host or Device
Low speed(1.5Mb/s) and full speed(12 Mb/s) operation in host mode
Full speed USB operaton in Device mode
Supports 32 endpoints
On-chip USB transceiver
Peripherals
CTMU supports Capacitive Touch applications
Perpheral Pin Select allows I/O remapping of many peripherals in real time
4xUART Modules with LIN and IrDA support, 4 Deep FIFO
3xSPI ™ Modules with 8 Deep FIFO
3xI2C™ Modules with Master and Slave Modes
Five 16-bit Timer Modules
Up to 9 Input Capture and 5 Output Compare/PWM with dedicated time base
Hardware RTCC, Real-Time Clock Calendar with Alarms
PMP, Parallel Master Port, with 16 Address Lines, and 8/16-bit Data
Parameter Name
 Value
Architecture
16-bit
CPU Speed (MIPS)
16
Memory Type
Flash
Program Memory (KB)
256
RAM Bytes
16,384
Temperature Range C
-40 to +85
Operating Voltage Range (V)
2 to 3.6
I/O Pins
52
Pin Count
64
System Management Features
BOR, LVD
POR
Yes
WDT
Yes
Internal Oscillator
8 MHz, 32 kHz
nanoWatt Features
Low Sleep/Fast Wake/Fast Control
Digital Communication Peripherals
4-UART
3-SPI
3-I2C
Analog Peripherals
1-A/D 16×10-bit @ 500(ksps)
Comparators
3
USB (ch, speed, compliance)
1, Full Speed (Device, Host, OTG), USB 2.0 OTG
Capture/Compare/PWM Peripherals
9/9
PWM Resolution bits
16
Timers
23 x 16-bit 11 x 32-bit
Parallel Port
PMP
Hardware RTCC
1
Cap Touch Channels
16
datasheet