Features:
CPU
Up to 16 MIPS performance
16 x 16 Hardware Multiply, Single Cycle Execution
12-bit x 16-bit Hardware Divider
C Compiler Optimized Instruction Set
nanoWatt Power Managed Modes
Run, Idle and Sleep modes
Multiple, Switchable Clock Modes for Optimum Performance and Power Management
Run mode: 1 mA/MIPS, 2.0V Typical
Sleep mode Current Down to 100 nA Typical
Standby Current with 32 kHz Oscillator:2.5 uA,2.0V typical
Flash Program Memory
Self-Reprogrammable under Software Control
10,000 erase/write cycles
20 year data retention
EEprom emulation capable
System
Internal oscillator support – 31 kHz to 8 MHz, up to 32 MHz with 4X PLL
On-chip LDO Voltage Regulator
JTAG Boundary Scan and Flash Memory Program Support
Fail-Safe Clock Monitor – allows safe shutdown if clock fails
Watchdog Timer with separate RC oscillator
Analog Features
10-bit ADC, 16 channels, 500k samples per second
Three Analog comparators
Universal Serial Bus Features
USB v2.0 On-the-Go compliant
Dual role capable, can act as either Host or Device
Low speed(1.5Mb/s) and full speed(12 Mb/s) operation in host mode
Full speed USB operaton in Device mode
Supports 32 endpoints
On-chip USB transceiver
Peripherals
CTMU supports Capacitive Touch applications
Perpheral Pin Select allows I/O remapping of many peripherals in real time
4xUART Modules with LIN and IrDA support, 4 Deep FIFO
3xSPI ™ Modules with 8 Deep FIFO
3xI2C™ Modules with Master and Slave Modes
Five 16-bit Timer Modules
Up to 9 Input Capture and 5 Output Compare/PWM with dedicated time base
Hardware RTCC, Real-Time Clock Calendar with Alarms
PMP, Parallel Master Port, with 16 Address Lines, and 8/16-bit Data
| Parameter Name | Value |
| Architecture | 16-bit |
| CPU Speed (MIPS) | 16 |
| Memory Type | Flash |
| Program Memory (KB) | 256 |
| RAM Bytes | 16,384 |
| Temperature Range C | -40 to +85 |
| Operating Voltage Range (V) | 2 to 3.6 |
| I/O Pins | 84 |
| Pin Count | 100 |
| System Management Features | BOR, LVD |
| POR | Yes |
| WDT | Yes |
| Internal Oscillator | 8 MHz, 32 kHz |
| nanoWatt Features | Low Sleep/Fast Wake/Fast Control |
| Digital Communication Peripherals | 4-UART 3-SPI 3-I2C |
| Analog Peripherals | 1-A/D 16×10-bit @ 500(ksps) |
| Comparators | 3 |
| USB (ch, speed, compliance) | 1, Full Speed (Device, Host, OTG), USB 2.0 OTG |
| Capture/Compare/PWM Peripherals | 9/9 |
| PWM Resolution bits | 16 |
| Timers | 23 x 16-bit 11 x 32-bit |
| Parallel Port | PMP |
| Hardware RTCC | 1 |
| Cap Touch Channels | 16 |
