8 Mbit Uniform Sector, Serial Flash Memory with Dual Data Mode 8-pin DIP
FEATURES
Single power supply operation
Full voltage range: 2.7-3.6 volt
8 Mbit Serial Flash
8 M-bit/1024 K-byte/4096 pages
256 bytes per programmable page
High performance
100MHz clock rate
dual data mode
Low power consumption
5 mA typical active current
1 μA typical power down current
Uniform Sector Architecture:
256 sectors of 4-Kbyte
16 blocks of 64-Kbyte
Any sector or block can be erased individually
Software and Hardware Write Protection:
Write Protect all or portion of memory via software
Enable/Disable protection with WP# pin
High performance program/erase speed
Page program time: 1.5ms typical
Sector erase time: 150ms typical
Block erase time 800ms typical
Chip erase time: 10 Seconds typical
Lockable 256 byte OTP security sector
Minimum 100K endurance cycle
Package Options
8 pins SOP 200mil body width
8 pins PDIP
8 contact VDFN
All Pb-free packages are RoHS compliant
Commercial and industrial temperature Range
GENERAL DESCRIPTION
The EN25T80 is a 8M-bit (1024K-byte) Serial Flash memory, with advanced write protection mechanisms, accessed by a high speed SPI-compatible bus. The memory can be programmed 1 to 256 bytes at a time, using the Page Program instruction.
The EN25T80 is designed to allow either single Sector at a time or full chip erase operation. The EN25T80 can be configured to protect part of the memory as the software protected mode. The device can sustain a minimum of 100K program/erase cycles on each sector.
Datasheet
