PIC24HJ64GP204-I/PT

116,000 

Features:
Operating Range
Up to 40 MIPS operation (at 3.0-3.6V)
Industrial temperature range (-40°C to +85°C)
Extended temperature range (-40°C to +125°C)
High-Performance CPU
Modified Harvard architecture
C compiler optimized instruction set
16-bit wide data path
24-bit wide instructions
Linear program memory addressing up to 4M instruction words
Linear data memory addressing up to 64 Kbytes
71 base instructions: mostly 1 word/1 cycle
Flexible and powerful addressing modes
Software stack
16 x 16 multiply operations
32/16 and 16/16 divide operations
Up to ±16-bit shifts for up to 40-bit data
On-Chip Flash and SRAM
Flash program memory
Data SRAM
Boot, Secure, and General Security for program Flash
Direct Memory Access (DMA)
8-channel hardware DMA
Up to 2 Kbytes dual ported DMA buffer area (DMA RAM) to store data transferred via DMA
Allows data transfer between RAM and a peripheral while CPU is executing code (no cycle stealing)
Most peripherals support DMA
Timers/Capture/Compare/PWM
Timer/Counters, up to five 16-bit timers
Can pair up to make two 32-bit timers
One timer runs as a Real-Time Clock with an external 32.768 kHz oscillator
Programmable prescaler
Input Capture (up to four channels)
Capture on up, down or both edges
16-bit capture input functions
4-deep FIFO on each capture
Output Compare (up to four channels)
Single or Dual 16-bit Compare mode
16-bit Glitchless PWM mode
Hardware Real-Time Clock/Calendar (RTCC)
Provides clock, calendar, and alarm functions
Interrupt Controller
5-cycle latency
118 interrupt vectors
Up to 45 available interrupt sources
Up to three external interrupts
Seven programmable priority levels
Five processor exceptions
Digital I/O
Peripheral pin Select functionality
Up to 35 programmable digital I/O pins
Wake-up/Interrupt-on-Change for up to 21 pins
Output pins can drive from 3.0V to 3.6V
Up to 5V output with open drain configuration
All digital input pins are 5V tolerant
4 mA sink on all I/O pins
Communication Modules
4-wire SPI (up to two modules)
Framing supports I/O interface to simple codecs
Supports 8-bit and 16-bit data
Supports all serial clock formats and sampling modes
I2C™
Full Multi-Master Slave mode support
7-bit and 10-bit addressing
Bus collision detection and arbitration
Integrated signal conditioning
Slave address masking
UART (up to two modules)
Interrupt on address bit detect
Interrupt on UART error
Wake-up on Start bit from Sleep mode
4-character TX and RX FIFO buffers
LIN bus support
IrDA® encoding and decoding in hardware
High-Speed Baud mode
Hardware Flow Control with CTS and RTS
Parallel Master Slave Port (PMP/EPSP)
Supports 8-bit or 16-bit data
Supports 16 address lines
Programmable Cyclic Redundancy Check (CRC)
Programmable bit length for the CRC generator polynomial (up to 16-bit length)
8-deep, 16-bit or 16-deep, 8-bit FIFO for data input
System Management
Flexible clock options
External, crystal, resonator, internal RC
Fully integrated Phase-Locked Loop (PLL)
Extremely low jitter PLL
Power-up Timer
Oscillator Start-up Timer/Stabilizer
Watchdog Timer with its own RC oscillator
Fail-Safe Clock Monitor
Reset by multiple sources
Power Management
On-chip 2.5V voltage regulator
Switch between clock sources in real time
Idle, Sleep, and Doze modes with fast wake-up
Analog-to-Digital Converters (ADCs)
10-bit, 1.1 Msps or 12-bit, 500 Ksps conversion
Two and four simultaneous samples (10-bit ADC)
Up to 13 input channels with auto-scanning
Conversion start can be manual or synchronized with one of four trigger sources
Conversion possible in Sleep mode
±2 LSb max integral nonlinearity
±1 LSb max differential nonlinearity
Comparator Module
Two analog comparators with programmable input/output configuration
CMOS Flash Technology
Low-power, high-speed Flash technology
Fully static design
3.3V (±10%) operating voltage
Industrial and Extended temperature
Low power consumptionParameter Name
 Value
Architecture
16-bit
CPU Speed (MIPS)
40
Memory Type
Flash
Program Memory (KB)
64
RAM Bytes
8,192
Temperature Range C
-40 to +85
Operating Voltage Range (V)
3 to 3.6
I/O Pins
35
Pin Count
44
System Management Features
BOR
POR
Yes
WDT
Yes
Internal Oscillator
7.37 MHz, 32.768 kHz
nanoWatt Features
Fast Wake/Fast Control
Digital Communication Peripherals
2-UART
2-SPI
1-I2C
Comparators
2
Capture/Compare/PWM Peripherals
4/4
PWM Resolution bits
16
Timers
5 x 16-bit 2 x 32-bit
Parallel Port
PMP
Hardware RTCC
1
DMA
8
Cap Touch Channels
13
datasheet

Danh mục: